Troubleshooting a Zebra Printer Made Easy
Technology is ever-evolving. The changes with technological revolutions are bound to happen. When it comes to Zebra printers, the same monotonous problems arise again and again over a period of time. The common issues that exist in a Zebra printer are poor print quality, skipping labels, none of the settings save, the wrong type of ribbon and paper, or even poor or low barcode ANSI grade.
Zebra printers are on priority these days and have gained significant importance in the recent past. They are the most reliable and give one of a kind experience. As they are easy to work on they have resulted in a positive outlet in the long run as many printers are neglected until something affects operation.
Though there can be serious technical issues, no matter what, it is advisable to thoroughly clean the printer as many printers are neglected until something affects operation. And once the cleaning is done a quick pause test can be taken to determine the proper functioning of the printer.
One can opt for the following set of instructions to solve the technical glitch. The steps are as follows;
- Restart your printer by switching it off for 2 minutes.
- Reset to factory defaults by holding down the single round button on the front panel.
- The indicator light will start a flash sequence: 1, 1-2, 1-2-3, and so on.
- Once the light flashes four times, release it. This resets your printer to factory defaults.
- Label width calibration.
- Hold down the button until it flashes twice, then release it. This will run an automatic set of calibrations on your printer.
The aforementioned steps are of great importance as they would contribute towards the seamless operation of the printer. How do you troubleshoot a Zebra label printer? If that is what is on your mind you can contact the given number for further information and clarity.
