Introduction:

Addition of Third-Party Cameras to Stopping-Area Putting one of these in place of your current brake light cameras (chmsl) will provide you with a backup camera in addition to the third brake light. You can avoid drawing attention to the backup camera by installing it in this location. Hence, a third brake light cam may be an asset.

3 Ways:

  • Superior Third-Brake-Light Camera Quality:

No special preparation is required to install a high-quality third brake light cameras; it may be attached to any flat service in the trunk. A high-quality imaging sensor will also be included.  Ideally, it would produce a clear picture even when little light was around. Choose a third-party camera for your brake lights with an up-to-date IP rating to hold up in any climate.

  • Choose a Display:

It is advised that a large, high-resolution TFT LCD screen be used with a third-party brake light cameras. While some screens are made to be mounted on the rearview mirror, others are made to take their place. If the screen can be installed next to, or in place of, the rearview mirror, it will not take up valuable dashboard real estate. Integrated controls, grid lines, and speakers are possible on some monitors. It’s possible to find screens as little as 4 inches and as large as 7 inches.

  • Conveyor Belt Transmitter and Receiver Multiplexer

The multiplexer manages the whole third brake light backup camera system. It takes video from the cameras and sends it to a display. Several cameras can be connected to this box. It’s typical when you have a car full of cameras.

Putting Your Brake Lights in the Third Position Why?

It’s possible to install the backup camera covertly. It won’t be visible to the naked eye and won’t change how the back of your car looks. If your vehicle doesn’t have a slot for a third brake light, you can still install such a cam on a flat surface.

  • The camera is protected from water damage by an assembly housed in the third brake light. Select cameras with the highest available IP certification to provide an extra layer of safety.
  • This position does not block this angle, even though the viewing angle varies from camera to camera. A camera with a 130-degree viewing angle should allow you always to see everything behind your car.
  • You can tell how advanced a third brake light backup camera is by allowing vans to be safely backed up. Installing a camera like this in the back of your car can increase your safety while driving. It’s a viable option for both delivery vans and passenger cars.

The camera, night vision sensors, various wiring and connectors, a high-resolution monitor, and necessary mounts are all part of a standard third brake light backup camera system. Excellent shock resistance is just one characteristic of a high-quality cam. 

Putting up a Trailer Camera for the Third Brake Light:

Large blind areas are difficult with trailers and cargo transportation of virtually any size, and these cannot be remedied with side mirrors alone. This makes it so that the rearview mirrors are largely worthless. In such cars, a third-brake-light camera system can save lives. 

The third brake light cameras equivalent to the original unit in function and form. Behind-the-scenes cameras are built right into the back bumper. A camera arrangement like this can provide a view of the bed or the fifth wheel. 

Conclusion:

A brake light cameras, mounted in the brake light, can be used with the other two. Hence, you may use these cameras to monitor your surroundings and any blind spots effectively. Remember all this information, and pick out a top-notch 3rd brake light cam for your car.