Nothing stands out like brand-new, freshly laid paver tiles on a concrete patio. Concrete pavers are a great choice you should think about if you’re sick of broken and ugly concrete surfaces close to your house.
However, can you do pavers over concrete, or must you first demolish it? This guide explains the fundamental steps in laying pavers and simplifies everything.
Pavers can always be put over concrete.
Homeowners often install driveway pavers on top of concrete rather than removing the existing concrete first, which is a messy and sometimes costly task. Fortunately, driveway pavers can be put straight over concrete that already exists. It is common practice and an excellent technique to enhance your concrete surfaces.
It is possible to install pavers without mortar, even though mortar is preferred when installing pavers (although it puts you at risk of drainage issues and cracking). To decide which paver installation method is ideal for your house and to receive a price estimate, speak with a local expert first.
But laying pavers over concrete isn’t always a smart option.
It’s not always a good idea to put driveway pavers on concrete. Therefore, removing the old concrete first is best if the surface is in really poor condition. Large cracks or a rough surface will hamper your attempts to install paver tiles. The higher the tiles need to be put, which could block doorways or cause people to trip, the worse the condition your area is in.
The higher the tiles need to be put, which could block doorways or cause people to trip, the worse the condition your area is in. Also, if the foundation is the problem, and it continues to settle, the pavers you put down will get damaged and need to be replaced.
How to Put Pavers Over a Concrete Surface?
Here’s an overview of the procedure in case you decide to handle it yourself:
Check for drainage issues.
Make sure the area you want to cover has a slope that allows water to drain off. If it isn’t, the existing concrete will prevent the water that seeps through your pavers from reaching the ground, leading to drainage problems and standing water where you don’t want it. Drill drainage holes a few inches apart if the slope is improper.
Clear the area.
Blast all that gunk off the existing concrete surface with a power washer to make room for the brand-new paver tiles. Before starting to place the pavers, let the surface completely dry.
Sand covers the existing concrete.
Cover the existing concrete with a layer of coarse sand between half and one inch thick. Your pavers will have a solid base due to this.
Spread the pavers.
The pavers can now be arranged in any way you choose on top of the concrete. Fit them with care, and then use the leftover sand to fill the gaps.
Use edging or mortar to keep the perimeter in place.
You’ll need to protect the border from holding the paver edges in place. To keep them in place, you can either use mortar, another type of adhesive, or a plastic edging tool that you hammer into position.
Take help from professionals to put driveway pavers at home depot properly today.
