Hydraulic presses can produce many thousands of pounds of force, making them useful for industrial operations such as forming metal parts. You usually measure hydraulic pressure in pounds per square inch (psi), which is the force per unit area. To calculate the power produced, multiply the pressure by the area of the piston in the hydraulic cylinder in square inches. This gives you force in pounds, which you can easily convert to tons. Collect data Look at the required data such as psi and cylinder piston diameter or area. This information can be found on the technical data sheet of the hydraulic press. Punching Press
Bending tool
A bending tool is a tool used in a bending machine to shape and process sheet materials. This tool is made up of different parts and different forms are made up of different parts. It mainly implements the processing of the product form by changing the physical state of the shaped material. It is a tool that used to produce a blank into a part with a certain shape and size under the pressure of a bending machine.
Structure of folding tools:
Press brake tools divide into a punch and a die, which are used for sheet metal forming and mold separation. The mold used for shaping has a hole and the mold used for dividing has a cut.
When installing the press brake, sure to check the equipment status, and then install and debug it according to the steps, and pay attention to personal safety when debugging.
Machine adjustment:
When installing the bending tool, you must first understand the performance of the machine, turn on the bender, adjust patiently, and check whether the machine has used dust and iron chips before. Avoid unnecessary problems for later use.
Shear stroke adjustment:
First, check whether the ratio between the thickness of the bending machine and the upper and lower modules is normal. The total slider should be set to the switch point of the stroke line. This must be taken into account, otherwise, the form is not commonly used, but some people often make such mistakes.
Setting the Lift Modulus:
After setting the rider lift standard, the next step is to set the upper limit point of the module. Generally speaking, when the module reaches the maximum point, the module and the switch should be set. In this way, the fixed position of the module can be streamed and the production efficiency can greatly increased through some of the above operations. In this process, the module must also be slowed down. Because the module must decelerate. When it is at the bottom dead center. Which protects the motor and the mold.
Uses of Nitrogen indifferent fields Nitrogen Generator
Gap adjustment: Finally, the gap between the bender forms is adjusted. First, the gap between the upper module and the lower module is measured, and the appropriate gap is determined according to the folded board.
