Changing a tyre is perhaps the most important sill one should know. A car is a machine and can break down anytime, anywhere. Changing a tyre is a skill that makes you independent. Many people depend on their mobiles, but a flat tyre is a situation that can occur anytime. You may have your phone at that moment or not. A mobile phone is neither a substitute nor a solution to a flat tyre.

Well, changing a tyre is not hard. It would help if you had the required tools. A jack, wrench, a spare tyre, and a vehicle manual are the 4 necessary tools required to replace a flat tyre. The spare tyre and all other equipment usually come with the vehicle only, but if looking for a spare tyre, then Pirelli tyres Leeds are one of the best to purchase. If one follows all the steps correctly, it usually only takes 15-30 minutes to change a tyre. The good thing is to practice changing your tyre in your garage only so that you are well versed with the procedure beforehand and do not panic when it happens.

Before starting with the procedure

As soon as you realise your flat tyre, the first thing is to stay calm and not panic. Do not apply a hard brake or take a turn. Keep driving slowly until you find a safe place, away from the traffic. Find a place with levelled roads to prevent your car from rolling. Do not try to change a tyre on the roadside of a narrow road.

Once you reach a safe place, here are a few other things to do before starting the actual procedure.

First and foremost, apply the handbrake and turn on the hazard lights to signal the other drivers on the road and avoid accidents.
All passengers should be out of the car.
Apply wheel wedges or chocks to the tyres Leeds present diagonally to the one that is replaced.

Loosen the wheel nuts

Before lifting your car with a jack, try to loosen the nuts or bolts of the tyre. Check your vehicle for locking wheel nuts. If the tyre has those, then try the locking key. Using the wrench, undo the nuts slowly. Turn them in the anti-clockwise direction. We only need to loosen them and not fully undo them.

Placing the Jack

The next step is to place the jack on flat land, away from the stones or any other debris. The Jack needs to be rightly placed beneath the frame of the flat tyre. You can also follow the instructions given in your car manual.

Once correctly placed, slowly lift your vehicle until the tyre is at least 6 inches above the ground. An important thing to keep in mind is never to put any part of your body, be it your hand or anything below the car, when lifting the vehicle.

Removal of the flat tyre

After the car is jacked up, slowly undo the wheel’s loose nuts and pull it towards you. Keep the nuts safely with you. The wheel might be heavy, so be careful. The tyre should come off quickly, but it may also require some persuasion. Set the wheel aside on flat ground to it doesn’t roll away.

Instalment of the spare wheel

The final step is to install the spare wheel. The spare wheel would slide easily if it has nuts and studs. But it may need some work if the spare tyre has bolts in aligning the holes. Make sure that you tighten the nuts or bolts properly. Then carefully lower your vehicle until it makes contact with the ground, and then remove the jack.

Remember, the spare wheel is just a temporary fix. These Tyres Leeds aren’t meant for long distances or high speeds. So after changing the tyre, make sure to visit the technician.